Tel: 13806160558
PRODUCTS Export

stainless steel pipe

linear units

SSAW Pipe production line

Polyester Staple Fiber Production Line

bituguard bitumen coating line

Hydraulic system & Electrical system

spare parts

IMPORT

Injection molding machine & Die casting machine

Press

Test equipment

Amplifier & Display (Accessories)

Current Location: Home > NewsNews

Production process of spiral steel pipe

(1) Raw materials are strip coils, welding wire, flux. Strict physical and chemical testing is required before input.

(2) The steel head and tail are butt jointed, and the single wire or double wire submerged arc welding is used, and the automatic submerged arc welding is used after the steel pipe is rolled.

(3) Before forming, the strip is leveled, trimmed, planed, surface cleaned and pre-bent.

(4) The electric contact pressure gauge is used to control the pressure of the cylinder on both sides of the conveyor to ensure the smooth conveying of the strip.

(5) Adopt external control or internal control roll molding.

(6) The weld gap control device is used to ensure that the weld gap meets the welding requirements, and the pipe diameter, the amount of misalignment and the weld gap are strictly controlled.

(7) Both internal welding and external welding are performed by single-wire or double-wire submerged arc welding by American Lincoln welding machine to obtain stable welding quality.

(8) The welded seams are all inspected by online continuous ultrasonic automatic injury inspection to ensure the non-destructive testing coverage of 100% spiral welds. If there is a defect, the alarm is automatically alarmed and sprayed, and the production worker adjusts the process parameters at any time to eliminate defects in time.

(9) The steel pipe is cut into individual pieces by an air plasma cutting machine.

(10) After cutting into a single steel pipe, each batch of steel pipe shall be subjected to a strict first inspection system to check the mechanical properties, chemical composition, fusion condition, surface quality of the steel pipe and non-destructive testing to ensure the pipe making process. After that, it can be officially put into production.

(11) The part of the weld with continuous acoustic flaw detection mark, after manual ultrasonic and X-ray review, if it is defective, after repair, it will pass the non-destructive test again until it is confirmed that the defect has been eliminated.

(12) The tube of the butt weld of the strip and the joint of the butt joint intersecting the spiral weld are all inspected by X-ray television or film.

(13) Each steel pipe is subjected to hydrostatic pressure test and the pressure is radially sealed. The test pressure and time are strictly controlled by the steel pipe water pressure microcomputer detection device. The test parameters are automatically printed and recorded.

(14) Pipe end machining, so that the verticality of the end face, the groove angle and the blunt edge are accurately controlled.

Contact Us

To provide you competitive products
Mobile: +86-13806160558
Tel: +86-510-86199585
Fax: +86-510-86199589
E-mail: goppelwang@landi-machinery.com
Skype: goppelwang
Room 4008,4th Floor, Huagang International Business Building,No.2 Chengshan Road,Jiangyin.Jiangsu
Copyright © 2019-2020 X-SENSORS Co., Ltd. All Rights Reserved.